Lock Operating instructions for ES Series Safes (ES1013, ES1310 & WES1310)

Upon installing the batteries, the electronics will perform
a self-check.

ON -» OPEN -» Error -» Lo-BAT -» TE -» good

To OPEN:

Press * then 7777 (Factory code) then #. After the signal
and OPEN appears on the display, turn the knob to the
right (within 4 seconds) to open the door.

To Change The Personal Code:

Two separate codes (1st) & (2nd) may be used with (2 to
6 digits in length).

(1st code) On the back of the door, press the change
button 5J, on the key pad press « .enter new personal
code, press #. Signal indicates accepted.
Be sure and try the code before closing the door.

(2"" code, only if desired) Press the change button ffl,
on the key pad press #, enter new personal code, press
#. Signal indicates accepted.
Be sure and try the code before dosing the door.

Caution!

If a wrong number is entered, ERROR displays.
If 3 wrong attempts, lock will power down for 5 minutes.

Emergency Bypass Key:

There is a key lock behind the battery compartment.
Slide the battery cover to the right and remove.
Remove the batteries. Un-snap the battery base from
the dips and carefully let hang out of the way. Insert
one of the keys provided with the safe and turn to the
left a full rotation and hold, then turn the knob to the
right and open the door.
Caution: Be sure and return the key back
counterclockwise before removing, or the lock will
remain open.

Note: If the keys are lost, the key number is stamped
on the face of the cylinder.

Low Battery:

When Lo-Bat appears in the window when entering
your code, it is time to replace the batteries. Repladng
batteries will not affect existing personal codes. Slide
the battery cover to the right and remove. Replace the
batteries with a good brand of Alkaline battery. Be sure
and place the (+) end of the battery in each position of
the base as indicated by the symbol.